Difference between revisions of "24ch DMX 8 RGB flood controller"
Jump to navigation
Jump to search
| Line 18: | Line 18: | ||
| − | ''' | + | |
| + | |||
| + | '''Resistors''' | ||
[[File:24ch-DMX-8-RGB-2.jpg]] | [[File:24ch-DMX-8-RGB-2.jpg]] | ||
| − | ''' | + | |
| + | |||
| + | |||
| + | '''Capacitors''' | ||
[[File:24ch-DMX-8-RGB-3.jpg]] | [[File:24ch-DMX-8-RGB-3.jpg]] | ||
| − | ''' | + | |
| + | |||
| + | |||
| + | '''ICs''' | ||
[[File:24ch-DMX-8-RGB-4.jpg]] | [[File:24ch-DMX-8-RGB-4.jpg]] | ||
Revision as of 10:27, 11 November 2015
DIP switch
- 1 - DMX through (pass DMX data as is, do not remove any channels)
- 2 - Use exponential lookup table to map channel value to PWM value (otherwise, mapping is linear)
- 3 - Invert output (when inverted in software, 0 will result in 0.05% PWM, so small glow might be visible)
S1 switch
- Power On - normal operation, listen on DMX input
- Press - test mode 1, rainbow
- Press - test mode 2, cycle RGB (0, R, G, B, RG, RB, GB, RGB, 0, ...)
- Press - normal operation
LED
DMX activity
Resistors
Capacitors
ICs
