Difference between revisions of "Singing Pixel Snowman"
| Line 13: | Line 13: | ||
/Boscoyo Pixel Strips - (approximately 6) | /Boscoyo Pixel Strips - (approximately 6) | ||
/Boscoyo ChromaTrim - (2) | /Boscoyo ChromaTrim - (2) | ||
| − | /Zip Ties 4" - hundreds | + | /Zip Ties /4" - hundreds /8" - a lot /11" - more than you might think |
| − | |||
| − | |||
/Boscoyo Custom Cut Snowman Face - (1) | /Boscoyo Custom Cut Snowman Face - (1) | ||
/Boscoyo ChromaHatMatrix Small - (1) | /Boscoyo ChromaHatMatrix Small - (1) | ||
I started my design by creating a Custom Coro face and hat, I worked with Boscoyo Studios to have these produced, as well as, building two spinners using 3/4" ADS plastic water pipe 100 PSI, and Boscoyo Pixel Strips. Laid out the head to be 18" (also surrounded by ADS pipe), spinner 1 (middle section of the body) to be 24", and Spinner 2 (lower body) to be 30" | I started my design by creating a Custom Coro face and hat, I worked with Boscoyo Studios to have these produced, as well as, building two spinners using 3/4" ADS plastic water pipe 100 PSI, and Boscoyo Pixel Strips. Laid out the head to be 18" (also surrounded by ADS pipe), spinner 1 (middle section of the body) to be 24", and Spinner 2 (lower body) to be 30" | ||
Revision as of 07:45, 20 August 2018
Building on the method I used for the StarFlake Spinner, I am adding two 7' Singing Snowmen to my Display.
Bill of Materials
Polyethylene Coil 3/4" 100 PSI pipe - (approx 20 Feet) /3/4-in Dia Coupling Plastic Coil Fitting (3) /2" Sched 40 PVC Pipe - (10 Feet) /2-in x 1-1/2-in dia PVC Schedule 40 Double Sanitary Tee Fitting - (1) /2" dia PVC Cap Fitting - (1) /2" to 3/4" PVC adapter - (2) /ProConnex 3/4-in EMT Connectors - (2) /Metallic 3/4" Emt 10-ft Conduit - (10 feet) /Boscoyo Pixel Strips - (approximately 6) /Boscoyo ChromaTrim - (2) /Zip Ties /4" - hundreds /8" - a lot /11" - more than you might think /Boscoyo Custom Cut Snowman Face - (1) /Boscoyo ChromaHatMatrix Small - (1)
I started my design by creating a Custom Coro face and hat, I worked with Boscoyo Studios to have these produced, as well as, building two spinners using 3/4" ADS plastic water pipe 100 PSI, and Boscoyo Pixel Strips. Laid out the head to be 18" (also surrounded by ADS pipe), spinner 1 (middle section of the body) to be 24", and Spinner 2 (lower body) to be 30"