Difference between revisions of "24ch DMX 8 RGB flood controller"
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
=== S1 switch === | === S1 switch === | ||
| − | Power On - normal operation, listen on DMX input | + | * Power On - normal operation, listen on DMX input |
| − | Press - test mode 1, rainbow | + | * Press - test mode 1, rainbow |
| − | Press - test mode 2, cycle RGB (0, R, G, B, RG, RB, GB, RGB, 0, ...) | + | * Press - test mode 2, cycle RGB (0, R, G, B, RG, RB, GB, RGB, 0, ...) |
| − | Press - default | + | * Press - default |
=== LED === | === LED === | ||
Revision as of 10:25, 11 November 2015
DIP switch
- 1 - DMX through (pass DMX data as is, do not remove any channels)
- 2 - Use exponential lookup table to map channel value to PWM value (otherwise, mapping is linear)
- 3 - Invert output (when inverted in software, 0 will result in 0.05% PWM, so small glow might be visible)
S1 switch
- Power On - normal operation, listen on DMX input
- Press - test mode 1, rainbow
- Press - test mode 2, cycle RGB (0, R, G, B, RG, RB, GB, RGB, 0, ...)
- Press - default
LED
DMX activity
Solder resistors
Solder capacitors
Solder remaining components and insert ICs
