Cheap ULN2803A Motor Driver
Revision as of 12:23, 17 August 2017 by Dirknerkle (talk | contribs)
- Normally, a PIC or other chip can't output enough current and/or voltage to drive a DC motor, and if the DC motor you need to control requires 500ma current or less at more than 5vdc, here's a cheap way to drive it. A typical, small hobby motor that needs 3.3vdc, 5vdc or even 12vdc is an example. To start, here's an outline of connections to the ULN2803A:
- And here's how you'd connect your controller to it:
- Additional information:
- Any controller that outputs a positive control signal should work, such as the Ren48LSD.
- The ULN2803A could conceivably control up to 8 motors, depending on their current draw (total < 500ma)
- The motor speed can also be controlled further by using common PWM operation in the PIC firmware
- The ULN2803A has a maximum voltage rating of 50vdc.