Singing Pixel Snowman

Building on the method I used for the StarFlake Spinner, I am adding two 7' Singing Snowmen to my Display.

Bill of Materials

Polyethylene Coil 3/4" 100 PSI pipe - (approx 20 Feet) / 3/4-in Dia Coupling Plastic Coil Fitting (3) / 2" Sched 40 PVC Pipe - (10 Feet) / 2-in x 1-1/2-in dia PVC Schedule 40 Double Sanitary Tee Fitting - (1) / 2" dia PVC Cap Fitting - (1) / 2" to 3/4" PVC adapter - (2) / ProConnex 3/4-in EMT Connectors - (2) / Metallic 3/4" Emt 10-ft Conduit - (10 feet) / Boscoyo Pixel Strips - (approximately 6) / Boscoyo ChromaTrim - (2) / Zip Ties /4" - hundreds /8" - a lot /11" - more than you might think / Boscoyo Custom Cut Snowman Face - (1) / Boscoyo ChromaHatMatrix Small - (1)

I started my design by creating a Custom Coro face and hat, I worked with Boscoyo Studios to have these produced, as well as, building two spinners using 3/4" ADS plastic water pipe 100 PSI, and Boscoyo Pixel Strips. Laid out the head to be 18" (also surrounded by ADS pipe), spinner 1 (middle section of the body) to be 24", and Spinner 2 (lower body) to be 30"